Kingston Scissor Lift Certification

Kingston Scissor Lift Certification - Scissor lift platforms are utilized at work locations to enable tradespeople - such as iron workers, welders and masons - to reach their work. Making use of a scissor lift platform is usually secondary to their trade. Hence, it is important that all platform operators be properly trained and certified. Lift manufacturers, regulators and industry work together to make sure that operators are trained in safely utilizing work platforms.

Scissor lift work platforms are also referred to as manlifts or AWPs. These work machinery are rather easy to use and provide a steady work setting, however they do have risks as they lift individuals The following are some important safety concerns common to AWPs:

To protect individuals working around work platforms from accidental power discharge due to close working proximities to power lines and wires, there is a minimum safe approach distance (likewise referred to as MSAD). Voltage can arc across the air and cause injury to workers on a work platform if MSAD is not observed.

In order to guarantee maximum stability, care must be taken when lowering the work platform. Moving the load towards the turntable, the boom should be retracted. This would help maintain steadiness if the -platform is lowered.

Rules do not mandate those working on a scissor lift to tie off. However, employees may be required to tie off if required by employer rules, job-specific risk assessments or local regulations. The anchorage provided by the manufacturer is the only safe anchorage to which harness and lanyard combinations must be attached.

Observe the maximum slope rating and do not go over it. A grade could be measured by laying a board or straight edge on the slope. After that, a carpenter's level can be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the length of the straight edge, then multiplying by 100, the per cent slope could be determined.

A standard walk-around check should be carried out to determine if the unit is mechanically safe. A site assessment determines if the work place is safe. This is important especially on changing construction locations because of the possibility of obstacles, contact with power lines and unimproved surfaces. A function test has to be performed. If the unit is operated correctly and safely and proper shutdown procedures are followed, the possibilities of incident are really reduced.

Click to Download the pdf